Designed by Singularity Computers and manufactured in the USA by Performance PCs.
This distribution plate fits onto the mid plate of the Phanteks Enthoo Elite, Caselabs SMA8, SMA8-A and STH10. It is designed to be used together with our Phanteks Elite Vertical Distribution Plate (which is also compatible with the Caselabs SMA8, SMA8-A and STH10) in a dual loop configuration. This distribution plate is for the GPU loop whereas the Phanteks Elite Vertical Distribution Plate contains both loops. One loop runs down to the Phanteks Elite Horizontal Distribution Plate and one loop runs up to the CPU area.
Material: Clear Cast Acrylic.
Fasteners: Stainless Steel Silver.
Gaskets: Silicone Black.
O-rings: Silicone Black and Clear.
Ports: x10. Outlets: x2. Inlets: x2. 6 Ports for connection to Protium 200mm D5 Reservoir Combos.
LED Strip: DRGB 5V Addressable.
Dimensions: Width: 220mm. Length 343mm. Thickness: 16mm. Full thickness with Protium Combos:
Phanteks Elite Vertical Distribution Plate: x1.
Phanteks Elite Horizontal Distribution Plate: x1.
Dual Protium 200mm Reservoirs
Spectrum 2.0 DRGB LED Strip: x1.
Mounting Fasteners: M4 22mm Button Head Hex: x4. M4 Nuts: x4.
Compatible with the Phanteks Enthoo Elite, Caselabs SMA8, SMA8-A and STH10. Use the included x4 M4 22mm and x4 M4 Nuts to attach to the reservoir mounting area next to the motherboard.
Phanteks Enthoo Elite: Align the distribution plate mounting holes with the mounting holes on the radiator mounting panel which fits next to the motherboard on the Phanteks Enthoo Elite, and use the included x4 M4 22mm Button head Bolts and x4 M4 Nuts for mounting.
Caselabs Cases: Use the distribution plate as a template to mark the mounting holes and drill them with a 4.5mm drill bit.
Install the Protium D5 Reservoir Combos onto the distribution plate using the included Bitspower Mini D-Plugs and 25mm Extension Fittings. Install the female side of the D-Plugs onto the Distribution Plate and the male side onto the matching ports on the Protium Combos (See diagrams). Use the 25mm Extension Fittings on the Quad Port Caps at the top of the Protium D5 Reservoir Combos so that they mount parallel to the distribution plate. Make sure all threads have been tightened, then push the Protium Combos onto the distribution plate via the Mini D-Plugs. O-ring grease can be used if the D-Plugs are too tight.
NOTE: Be careful if removing the Protium D5 Reservoir Combos to pull up evenly or the threads can be broken due to leverage!