The Caselabs Vertical Distribution Plate Des1 fits onto the Reservoir Panel of the Caselabs Magnum THW10, TH10, TX10, STH10, SMA8 and SMA8-A. It will also fit into any other case the dimensions allow. It fits two Protium 200mm Pump Reservoir Combos so that you can have the best of both worlds, a Singularity Computers Distribution Plate and Protium Combos. This is a dual loop distribution plate. There are 24 ports, 12 on each side. 8 of the ports on the front are for connecting Protium Pump Reservoir Combos and the 8 ports on the back which mirror these are for fill, drain and accessories. The other ports are inlets and outlets and they are on the front and back so that you can connect from either side for single or dual compartment cases. Each Protium Pump Top Outlet runs directly into the distro and the outlets are configured to align tubes to run over your top GPU, one for the GPU loop and one for the CPU loop. Then there are return lines at the top and bottom of the distro each returning to an inlet on each of the Protium Combos.
Created with a manufacturing process used in industries such as aerospace. All components are carved from a solid block of material. Over engineered for maximum strength and lifespan. Stainless steel fasteners for maximum strength and corrosion resistance. Gaskets instead of O-rings for increased durability. No threads in the acrylic, instead we use stainless steel thread inserts. Our designs are consistently improved and optimized.
CNC Machined Cast Acrylic.
Stainless Steel Fasteners.
Large fluid volume.
Thread inserts instead of threaded acrylic.
Material: Cast Acrylic Clear: 10mm.
Manufacturing Process: CNC Router.
Gaskets: Silicone Black.
Dimensions: Height: 380mm. Width: 275mm. Thickness: 20mm.
Dimensions: Fits onto the Reservoir Mounting area next to your motherboard.
Fasteners: M4 Stainless Steel Silver.
Ports: 24 G1/4” Ports.
Caselabs Vertical Distribution Plate Des1.
Stop Fittings: x8.
Mounting Fasteners: M4 25mm x4. M4 Washers x4. M4 Nuts x4. Stainless Steel Silver.
Install onto the reservoir mounting area next to the motherboard. Mounting holes must be drilled and the distro can be used as a template for the hole positions. Design specifically for use with Singularity Computers Protium 200mm Pump and Reservoir Combinations. Outlet Holes are aligned so that tubes can be run over your top GPU to make Outgoing connections to two separate loops one for the CPU and one for the GPUs. There are ports on the back side of this distribution plate for fill, drain and accessories. These ports do not have to be used but if you would like to use them then the mounting area must be modified to gain access to them from the rear side of the case.
To connect the Protium D5 Reservoir Combos to the distribution plate the following fittings are required to make all connections. Three of the four connections on each Protium Combos are required if you would also like to add a Temperature Sensor to each loop along with a fill port and drain port. We have allowed for all four to be connected because these connections also mount the Protium Combos. Select the addon option and we will include these fittings along with factory assembly.
Bitspower Mini D-Plug x8.
Bitspower 25mm Extension Fitting x4.